conteHome > Ice Maker > Kitchenaid Refrigerator Ice Maker Not Working

Kitchenaid Refrigerator Ice Maker Not Working

Contents

Matt Spencer 138.398 görüntüleme 17:36 Daha fazla öneri yükleniyor... Youtube Icon Facebook Icon Twitter Icon Terms of SaleTerms of UsePrivacy Policy Need Help? Cause 11 Water Filter A clogged water filter can restrict the flow of water to the dispenser and prevent the ice maker from working properly. Oturum aç 243 Yükleniyor... this content

Find out more » Total: $101.35 Add to Cart Cause 12 Icemaker Mold Thermostat The icemaker mold thermostat monitors the temperature of the ice mold (ice tray). For some reason the ice maker seemed to overheat and started to defrost the freezer. If nothing obvious has caused the ice buildup then suspect the inlet valve, tubing or low water pressure. On the very first service call, the serviceman stated that KitchenAid knew about this defect and would stand behind its product.

Kitchenaid Refrigerator Ice Maker Troubleshooting Red Light

Find out more » Total: $68.46 Add to Cart Cause 3 Ice Maker Assembly One component of the ice maker assembly might be defective. So when it arrived, and I took it out of the box, here's what it looked like: KitchenAid, Whirlpool, Kenmore ice maker with "damaged" packaging There's a small rip in Check to make sure there are no kinks in the water supply line. If there is no light your LED light may be out, you may have pre 2002 boards installed, or the optics boards need to be replaced.

Daha fazla göster Dil: Türkçe İçerik konumu: Türkiye Kısıtlı Mod Kapalı Geçmiş Yardım Yükleniyor... Guns. Find out more » Total: $100.94 Add to Cart Cause 3 Ice Maker Assembly One component of the ice maker assembly might be defective. Kitchenaid Refrigerator Ice Maker Leaking Water He enjoys listening to others' opinions before politely pointing out that they're completely wrong. | Read more Latest TweetsMy Tweets Get Blog Updates Enter your email address to subscribe to this

The water inlet valve requires a minimum of 20 psi to function properly. Kitchenaid Undercounter Ice Maker Troubleshooting If the water inlet valve has sufficient pressure and is getting power, but the ice maker won’t fill with water to make ice, replace the water inlet valve. Check the water flow and test the pressure to determine if it is at least 20 psi. I want some level of concern on behalf of Whirlpool/KitchenAid, whose appliances I will never buy nor promote.

Next time, we'll head to Sears where the appliances are reasonably priced and will at least hold up more than 2 years. Kitchenaid Ice Machine Not Making Ice This video demonstrates how to test a water inlet valve on a refrigerator. ... In addition, check to see if frost has accumulated on the evaporator coils. Besides, I'd already taken my old one apart previously when troubleshooting it, so I knew it was just a matter of a few screws and less than 5 minutes to partially disassemble both

Kitchenaid Undercounter Ice Maker Troubleshooting

If the water pressure is sufficient, use a multimeter to check for power to the water inlet valve. Lütfen daha sonra yeniden deneyin. 11 Eki 2012 tarihinde yayınlandıIf you have these symptoms then your ice make may have the same problem as this one.•Tines/fingers down•Ice cubes unmoved in tray•If Kitchenaid Refrigerator Ice Maker Troubleshooting Red Light SteveJenkins.com Product Reviews. Kitchenaid Refrigerator Ice Maker Won't Dispense Ice Open the freezer door, close the flipper on the left side and watch the status LED on the right side.

Every now and then I'd hear the magical "hissing" of water flowing into the ice maker, and then later hear the "clunk clunk clunk" of 8 cubes at a time falling news Probably -- if it's just a loose or corroded connection. Any help would be greatly appreciated. If the tube is clear then perform the ice maker troubleshooting as described in one of our previous posts: Water to ice maker quit working Post the results. Kitchenaid Stand Alone Ice Maker Troubleshooting

The machine did not work one single day. Remove jammed ice from the ejector arm using only a plastic utensil so the ice maker is not damaged.The ice may jam due to not purging air from the water line. When I open the door the led flashes twice and then shuts off and waits a second before flashing twice again. http://sparcweb.net/ice-maker/kitchenaid-refrigerator-superba-ice-maker-not-working.php Part Testing Watch this helpful video to determine if this may be the cause of your issue.

In addition, check to see if frost has accumulated on the evaporator coils. Whirlpool Side By Side Ice Maker Not Working If dirt has gotten into the valve it may not shut off completely and will continuously drip water into the ice maker fill tube and will eventually freeze up. james pupello Good job!

If the freezer temperature is too high, ensure that the condenser coils are clear of debris and the condenser fan is working properly.

I didn't know if it would make any difference once installed (looking back, probably not), but I didn't want to take any chances. When I asked for the CEO's name and address yesterday, the CS rep said we don't have that info. If the ice level control board fails, the ice maker will stop making ice. Whirlpool Gold Ice Maker Not Making Ice I am disappointed and disgusted with this purchase.

Mechanically, this is a Whirlpool modular ice maker with a few extra trim pieces, different fill tube location, and a set of control boards have replaced the bail arm switch. They charged $98 for the service call and gave a quote for additional $307.00 for a total charge of $405 which was paid when they change the parts that THEY DICTAMINATED Ice, Ice, baby! check my blog I got a new replacement fridge.

Then the ice maker stopped completely. You could be right.

nt