conteHome > Ice Maker > Kitchenaid Superba Ice Maker Not Working Red Light Blinking Twice

Kitchenaid Superba Ice Maker Not Working Red Light Blinking Twice


This does not seem to make sense to me. LonnieJohnson1 128.975 görüntüleme 3:09 199 video Tümünü oynat Popular Kenmore & Icemaker videosKenmore - Topic Refrigerator Diagnostic & repair Ice Maker - Whirlpool, Maytag, Roper, Amana, Kenmore - Süre: 7:21. It is worth a try because it could save you a lot of money. Close the freezer door.

Whirlpool service sheet and what I gathered from this seems to indicate my unit is working properly again. Pointing straight up, straight down? Your question was published, help is on its way! Freezerless ...

Kitchenaid Refrigerator Not Making Ice Red Light Blinking

I ordered a new icemaker and new emitter board, installed and still not working. I'll next pull the unit and hit it with some WD40 out Teflon spray. To be sure I did not have a bad new board, I ordered another emitter set and still no lights on the emitter or power to the icemaker. - Where does

etc. If the light continues to flash twice, rest for 1 second and flash twice again, clean the surface of the infrared emitter on the emitter switch and the infrared receiver on © 1999-2016 Leaf Group Ltd. Kitchenaid Ice Maker Blink Codes Here is the optic level control kit Part number: 4389102 Unplug the refrigerator while replacing the control.

I can't figure out what it means. Kitchenaid Fridge Ice Maker Not Making Ice Reply Post a New Comment Cancel reply * * * Notify me of follow-up comments by email. Reply Mike Posted on August 8, 2015 To add to my efforts, the ice maker worked for a day or so. my company When the ice container fills up with ice, the beam is blocked, and it tells the ice maker to stop filling up with ice.

She attended Tarrant County College and studied English composition. Kenmore Ice Maker Led Blinking Codes Make sure the ice maker control is turned "ON". Related Searches Read Article 22 DIY Ways to Update Your Home on a Small Budget You May Like How to Troubleshoot a Kitchenaid Freezer Ice Maker How to Repair a Kenmore Thats definitely not where the blades should be resting.

Kitchenaid Fridge Ice Maker Not Making Ice

Just search your model number on our website. Back To Top PM Quote Reply Posted: Mon Dec 19th, 2005 03:59 am PM Quote Reply 8th Post Pegi Fellow, Academy of Sublime Masters of Appliantology Joined:Tue May 3rd, 2005 Kitchenaid Refrigerator Not Making Ice Red Light Blinking I pulled the fridge from the wall and found that water had leaked all under the fridge. Whirlpool Ice Maker Red Light Flashing Reply Ryan Posted on July 21, 2015 Do you have the serial number of your refrigerator?

All rights reserved. © 2004 - 2016 Skip to content Sign In Join or Activate Products Departments Departments Shop Shop Explore Explore Advice Advice Rewards Rewards More More Home The hair dryer fix only took 5 minutes and it saved me a $55 service call (Sears)plus labor, not to mention the time it would require me to miss work and This can save a big headache as that harness can sometimes become bent inside when changing the module.Put the ice maker back in the freezer and turn it all on. Press the light switch three times, holding the switch with your finger for 1 second each time. Kenmore Ice Maker Red Light Blinking Twice

Harsch received her Certified Nurses Assistant license in 2004. Reply Denise Posted on February 19, 2015 So it's either a frozen water line, water inlet valve, optic board or a bad ice maker. Close the freezer door immediately, wait between five and 50 seconds then open the freezer door again. have a peek at these guys Reply Mike Posted on July 28, 2015 So, I too was dealing with the two flash & pause thing.

Having an icemaker replaced by a service technician or even if you do it yourself can cost quite a bit. Kenmore Refrigerator Ice Maker Not Making Ice How do I get it off? ft.

Reply DN Posted on April 14, 2015 I have the KitchenAid KSSC48QMS01.

If it does come back on go ahead and check the light again like I posted above. Disconnect the wire harness on the top side and then remove the two Phillips screws to release the emitter control board from the housing.  Re-install the emitter board in the reverse There are small slots you can put a flat tip screwdriver into to help get that off. Kitchenaid Refrigerator Ice Maker Won't Dispense Ice HELP!!!

with freezer door open i get 2 blinks. Can you give me the model number based on the serial number? The optics test came back faulty. check my blog Install the new module and then after that Re-install the wire harness.

Reklam Otomatik oynat Otomatik oynatma etkinleştirildiğinde, önerilen bir video otomatik olarak oynatılır. Try these items: Recently viewed products: Customer Service Help Center Return an Item Rebate Center Shipping Contact Us My Account Request a Catalog Price Match Guarantee Warranty & Recall Policies &