conteHome > Iphone 4 > Iphone 4s Headphone Jack And Speaker Not Working

Iphone 4s Headphone Jack And Speaker Not Working


Then set up a Genius Bar appointment to get it fixed. javamonk - 06/26/2014 Reply Agreed, mine was stuck inside of the back cover fidelvila - 07/22/2014 Reply So was mine - thanks for telling! This may require a significant amount of force. Sharn de Wet - 05/27/2014 The only way to turn on an iPhone without a power button is to plug it in to power. this contact form

The phone still works and everything else is fine, it's just annoying that I have a SIM holder sticking out about 1mm. See the video below. This step is less drastic than the next, but you wil lose some settings. Start lifting off the connector from the bottom side, by placing the tip of the tool between the loudspeaker enclosure and the metal cover of the connector.

Iphone 4s Ear Speaker Not Working

One more tip.. To activate Control Center, use your finger to swipe up from the very bottom of the screen. Then, I worked it from the bottom to the top.

Heat the chip as described at temperature 300 deg C for 5 minutes. Advice, find a decent philips heard screwdriver for the internal screws like the two found on the battery connector. I removed it from the logic board because the warning was after the instructions. Iphone 4s No Sound Bar What I did was I took out the battery, the tin plate above the cables, and lifted the dock connector.

griffn - 09/10/2015 Reply Add a comment Add Comment 1024 Step 21 Edit Use the edge of a plastic opening tool to disconnect the Wi-Fi antenna from the logic board. 4 Iphone 4s Speaker Not Working During Calls jimforbes - 05/23/2014 Reply It's also called glad wrap in the US as well. :) Scorppio500 Webmaster - March 31 After seeing the comments about trouble finding the carrier, I shut I put it back in place as best I could during reassembly and so far haven't ran into any problems. After resetting all my settings to factory (do not do this until all else fails), it still didnt work.

It's under. Iphone 4s Volume Button Not Working Unplug the headphonesHopefully one of those works Dec 2, 2012 2:49 PM Helpful (0) Reply options Link to this post by deggie, deggie Dec 2, 2012 2:54 PM in response to A hard reset using both top off button and Home button at same time (didn't work)3. Remove the rear panel from the iPhone. 4 comments On reassembly, be sure to clean the metal plate at the place of contact with the tiny pressure contact mentioned in step

Iphone 4s Speaker Not Working During Calls

Hardware: The built-in speaker on the bottom of your iPhone converts the software's instructions into sound waves you can hear. It took less than 5 minutes with most of the time spent trying to prise out the battery as it was glued in nice and tight but steady pressure from the Iphone 4s Ear Speaker Not Working You can do this with an emery board or sand paper. Iphone 4s Sound Not Working removing the battery resets internal clock to start value and your provider doesn't accept that, hence no network.

Elle doit bien continuer à dépasser de manière a faire contact avec le dos de l'iphone. weblink How To Fix iPhone Speaker Problems 1. There are less-expensive alternatives too: CellSavers will come to you and repair your iPhone on the spot in as little as 30 minutes (and offer a lifetime warranty), and is After that Iphone was switched on, and it seems to be working fine at the moment, but I am very scared, if it will continue to work well without that small Sound Not Working On Iphone 6

Ray Leahy - 06/07/2015 Reply The physical battery replacement went off without a hitch, and saw that the phone had no network connection, but also had no way to unlock. kct16k - 03/15/2014 I just ripped off the power cable ... I get sound through headphones, but not through speakers. iPhoneRepairMia 130.391 visualizaciones 8:11 Loud Speaker Repair - iPhone 4 How to Tutorial - Duración: 6:02.

Advertisement Saw Tun explains the issue in the video above, and how he went about fixing the issue. Iphone 4 Speaker Not Working Jack - 11/03/2013 Reply Why isn't it moving? jurajtomecek7 - 01/28/2015 Reply I used my 16x magnifier loupe to be certain I had the pressure sensor aligned with the screw hole - no problem, no stripping.

We're willing to bet the same issue happens with some Android phones too, so it's worth keeping in mind even if you don't have an iPhone or iPod Touch.How to fix

A 4S i have here has the left hole bigger and one of the screws didn't want to go into the right hole when it went nicely into the left one. David Bruce - 09/23/2013 Reply I had challenges here. List iPhone 5C Hardware Diagram Article Learn How to Pair Bluetooth Devices to Your iPhone List Get to Know the 5th Generation iPod Touch List Want to Know What Every iPhone Dock Connector Iphone 4s After resetting the network settings in settings it did work perfectly!

Cola de reproducción Cola __count__/__total__ iPhone 4s speaker wont work- here how you fix it Ahmad A SuscribirseSuscritoCancelar1616 Cargando... The best part is, you should have sound again. Issues could range from system sounds working but your iPhone not actually ringing or system sounds not working unless plugged into the headphone jack. his comment is here Since I've updated my iPod Touch 4th gen to iOS 6, I have experienced that I CANNOT lower the sound at all!!