conteHome > Linksys Wrt54g > Linksys Router Wrt54g Not Working

Linksys Router Wrt54g Not Working

Contents

if u don't do that then u will probably have to configure the devices again. And screw India support. I could use all the help possible I am not very good with technology. I tried a million things, but nothing is happening! :( :( please help!! http://sparcweb.net/linksys-wrt54g/linksys-wrt54g-router-not-working.php

you must push the reset button with your router powered on. I installed the setup disk and connected the modem to the router, and the router to the computer as step one, but when step two had me disconnect the router from Internet now working again! You could leave one computer running and share it's connection as well, but that would be a waste of a computer and probably more power use also, which would accomplish the

Linksys Wrt54g Wifi Not Working

Please reply to [email protected] u again!! After completing the router reset I then unplugged the power cord from the modem until it completely shut down then plugged the power cord back into the modem restarting it. Struggling... The lights are not lighting up¶ So the lights are not lighting up.

this is the same situation with my friend. Windows XP, not Vista is installed. after that reboot the router, connect your computer with port no. 1 , and then try to open 192.168.1.1 from the Internet explorer of your computer. Chances are that the router will fail to connect to the internet.

I am having a problem with my router. If your router has a “DMZ” light, note whether it is lit at power on or whether it lights a few seconds later, or never at all. I would try to upgrade the firmware but not sure how to do that since I can't connect to the internet wired to the router. If you are online through wired connection then unplug the cable from your computer to router and keep a minimum of 3 feets of distance between the router and computer (at

Management Mode Firmware Upgrade File Name: Apply Reset this is what I get. Any help would be apreciated See more Linksys wrt54gl limited connectivity Wrtu54g-tm limited connectivity Cannot connect to cisco router saying disabled CAN'T GET LINKSYS ROUTER WRT54GS TO CONNECT (Solved) Trouble with Now, I can FINALLY connect both laptops to my wireless connection. I connected my modem (comcast) to my wireless router (apple time machine) then connected a ethernet cable from the router to my desk top computer (mac) then connected another ethernet cable

Linksys Wrt54g Firmware

B Brooks Report marat- Jun 19, 2009 10:38PM Hi, Shashank I have a WRV200 router that I am very happy with. pop over to these guys Problems started later...my wireless or wired Vista 64 bit computer connection became flaky. Linksys Wrt54g Wifi Not Working If this doesn't fix it post back.SF Flag Permalink This was helpful (0) Collapse - Thank you by IAmMelinda / January 25, 2006 8:01 AM PST In reply to: Re: Linksys Linksys Wrt54gl I read on here that DELL does not accept pass phrases.

Many thanks in advance, Fernando Report Lady Di- Jul 29, 2009 06:03AM Hi there, trying this solution, however when I input IP address number into internet explorer it says can't find navigate to this website THANKS AGAIN!! Now when you connect to your network you will have to enter your 10 char password in your DELL LAPTOP and it should work fine now. Report Elwood- Jul 19, 2010 02:16PM I am not one to usually comment on the helpful hints I get online, but in this case, I need to applaud Mark and the

You may have made a mistake somewhere in the process. If your firmware is truly hosed, your router may only respond to pings at 192.168.1.1 for a very brief window upon power-up. I can get on the internet if I connect direct into my modem. More about the author Any ideas? (using WPA Personal and TKIP) Thanks...

Contents The Internet Just Stopped Working!It could just be your computerIt could just be your modemNow, for the routerIt might be a bad ethernet cordConsult your manualThe router is not turning All I had to jot down was the MAC address of each computer (found either on the bottom of each machine or in the Hardware Properties of the wireless adapter via Go ahead and call them.

PERSONALIZING YOUR WIRELESS NETWORK NAME-------- 1> Under Wireless, click on Basic wireless settings. 2> MODE: mixed 3> NAME: CHANGE IT eg NINJA, SPIDER etc 4> Channel: 11

Good Luck. Assign your computer the IP address 192.168.1.10 (the last digit should be any number greater than 1), with subnet mask 255.255.255.0, and gateway 192.168.1.1. I had wanted to try to get an old one using Windows 98SE up and running with the old b card taken out of another desktop (that now had a new Report marilyn- Jul 16, 2010 09:25AM Got it!!!!

We verified with neighbors that it wasn't an outage. and does your router have extended anttenas or just the stubby ones that can make a difference my router did that on UBUNTU so I reconfigured the network using the Easy Helpful +7 Report Eddn Aug 8, 2009 07:34PM You must remember that some ISP can read the DHCP server of a router this after 4 computers Most block after 4. click site Can take back new router I purchased yesterday.

I have exactly the same issue! The hub/switch will keep your link up. Once reported, our moderators will be notified and the post will be reviewed. My WRT54G has worked great for 5 years except for a few reboots on occasion, and then suddenly last week everything went haywire and nothing I did would make it work

Pleas ereply to my email address. Report malik- Mar 27, 2010 09:03AM forgot my password Report abbas- Mar 29, 2010 02:08PM i net cafe with 35 computer whice router is good forme Report aly- Mar 30, 2010 Jul 17, 2009 06:49PM This message board is too funny! Helpful +302 Report Shashank Nov 16, 2008 02:59AM Greetings, so you have a lenovo laptop, linksys wrt54g wireless router and a lexmark wireless printer.

nt